Circuit/System Verification
WARNING: This page is about a different variant/trim than selected.
- Ignition On, verify DTC UXXXX is not set.
- If a DTC is set
Refer to Diagnostic Trouble Code (DTC) List - Vehicle .
- If a DTC is not set
- If a DTC is set
- Engine idling.
- Verify DTC P203B is not set.
- If the DTC is set
Replace the B213 Reductant Level Sensor.
- If the DTC is not set
- If the DTC is set
- Verify the scan tool parameters listed below display OK or Not Run:
- Reductant Level Sensor 1 Circuit Status
- Reductant Level Sensor 2 Circuit Status
- Reductant Level Sensor 3 Circuit Status
- If OK or Not Run is not displayed
Refer to Circuit/System Testing.
- If OK or Not Run is displayed
- Operate the vehicle within the Conditions for Running the DTC. You may also operate the vehicle within the conditions that you observed from the Freeze Frame/Failure Records data.
- Verify the DTC does not set.
- If the DTC sets
Refer to Circuit/System Testing.
- If the DTC does not set
- If the DTC sets
- All OK.