Conditions for Running the DTC
WARNING: This page is about a different variant/trim than selected.
- DTC P0045, P0047, P0048, P007C, P007D, P0101, P0102, P0103, P0106, P0107, P0108, P0112, P0113, P0117, P0118, P0128, P02E0, P02E7, P02E8, P02E9, P02EB, P0400, P0403, P0405, P0406, P0489, P0490, P122C, P122E, P122F, P140D, P140E, P140F, P1407, P2228, P2229, P2263, P2453, P245A, P245C, P245D, P2564, P2565, P2598 or P2599, is not set.
- Engine speed is between 1, 500-2, 600 RPM for at least 10 s.
- Battery voltage is greater than 11 V.
- Calculated fuel rate is between 20-65 mm3 .
- Ambient air temperature is greater than -7°C (19.4°F).
- Engine coolant temperature is greater than 70°C (158°F)
- Barometric pressure is greater than 74.8 kPa (10.9 psi).
- MAF is between -0.5 to -0.03 g/s.
- EGR valve is in closed loop and active for greater than 1.5 s.
- Diesel particulate filter (DPF) system is not in regeneration mode.
- EGR valve actuator position is between 1-51%.
- The DTCs run continuously when the above conditions are met.