Circuit/System Testing
WARNING: This page is about a different variant/trim than selected.
- Verify the conditions listed below do not exist:
- Intake air flow blade that is not in the rest position.
- Intake air flow blade that is binding open or closed.
- Intake air flow blade that opens or closes without spring pressure.
- Dirt, debris or coking in the intake air flow body.
- Damaged intake air flow valve blade or shaft.
- If a condition exists
Clean or replace the Q20 Intake Air Flow Valve as necessary
- If none of the conditions exist
- Test or replace the Q20 Intake Air Flow Valve.