LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2015 >> Cruze LT, Automatic Trans >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 12 (Engine Controls And Fuel - 2.0L (LUZ) Diesel - DTC P0430 To DTC P2080) >> Diagnostic Information and Procedures >> DTC P11DB, P11DC, P2200, P2202, P2203, P2205, P2209, P229E, P220A, P220B, P22A0, P22A1, P22A3 or P22A7: NOx Sensor Circuit >> Repair Verification

Repair Verification

WARNING: This page is about a different variant/trim than selected.
  1. Install any components or connectors that have been removed or replaced during diagnosis.
  2. Perform the scan tool NOx Sensor 1 or 2 Reset procedure after replacing the NOx sensor 1 or 2.
  3. Clear the DTCs.
  4. Ignition Off, all vehicle systems Off, this may take up to 2 minutes.
  5. Ignition On.
  6. Command the Reductant System Data Reset On with a scan tool.
  7. Ignition Off, all vehicle systems Off, this may take up to 2 minutes.
  8. Ignition On, verify the Service Emission System message or reductant lamp turns Off, if illuminated
    • If the Service Emission System message or reductant lamp does not turn Off 

      A condition with the system still exists

    • If the Service Emission System message or reductant lamp turns Off 
  9. All OK.
scientia non olet · About LEMON Manuals