Repair Verification
WARNING: This page is about a different variant/trim than selected.
- Install any components or connectors that have been removed or replaced during diagnosis.
- Perform any adjustment, programming or setup procedures that are required when a component or module is removed or replaced.
- Clear the DTCs.
- Ignition Off, all vehicle systems Off, this may take up to 2 minutes.
- Ignition On, perform the Reductant System Quality Test with a scan tool.
- Engine idling for at least 5 min.
- Ignition Off, all vehicle systems Off for 5 min.
- Ignition On, verify the DTC is not set.
- If the DTC is set
A condition with the system still exists.
- If the DTC is not set
- If the DTC is set
- All OK.