Conditions for Running the DTCs
WARNING: This page is about a different variant/trim than selected.
- DTCs P0101, P0234, P0299, P0401, P0402, P140B, P140C, P2200, P2202, P2203, P2205, U029D and U029E are not set.
- Battery voltage is greater than 11 V.
- Ambient air temperature is greater than -7°C (19°F)
- Engine speed is less than 1000 RPM for at least 10 s.
- BARO pressure is greater than 75 kPa (11 psi).
- EGT sensor 3 is between 50-500°C (112-932° F).
- NOx 2 NOx Concentration is less than 200 ppm.
- The DTC runs during key off after-run after the above conditions are met and the fault exists for more than 3 events during a key cycle.