Component Testing
WARNING: This page is about a different variant/trim than selected.
- Ignition Off, disconnect the harness connector at the Q61 Emission Reduction Fluid Injector.
- Test for 10-14 Ω between the reductant dosing valve high control circuit terminal 2 and the reductant dosing valve low control circuit terminal 1 of the Q61 Emission Reduction Fluid Injector.
- If not within the specified range
Replace the Q61 Emission Reduction Fluid Injector.
- If within the specified range
- If not within the specified range
- Test for infinite resistance between each terminal and the Q61 Emission Reduction Fluid Injector housing.NOTE: Touching the injector connector plastic housing during this test will create a false resistance reading on the DMM. Use terminal test leads to prevent false readings.
- If not infinite resistance
Replace the Q61 Emission Reduction Fluid Injector.
- Infinite resistance
- If not infinite resistance
- All OK.