Circuit/System Verification
WARNING: This page is about a different variant/trim than selected.
- Ignition ON.
- Using a scan tool observe the following parameters.
Verify that NO parameters display Malfunction.
- Cylinder 1, 2, 3 or 4 Glow Plug Control Open Test Status
- Cylinder 1, 2, 3 or 4 Glow Plug Control High Voltage Test Status
- Cylinder 1, 2, 3 or 4 Glow Plug Control Low Voltage Test Status
- If Malfunction is displayed
Refer to Circuit/System Testing.
- If Malfunction is not displayed
- Operate the vehicle within the Conditions for Running the DTC to verify the DTC does not set. You may also operate the vehicle within the conditions that you observed from the Freeze Frame/Failure Records data.
- If a DTC sets
Refer to Circuit/System Testing.
- If a DTC does not set
- If a DTC sets
- All OK.