LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2015 >> Cruze LT, Automatic Trans >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 12 (Engine Controls And Fuel - 2.0L (LUZ) Diesel - DTC P0430 To DTC P2080) >> Diagnostic Information and Procedures >> DTC P0627-P0629: Fuel Pump Relay >> Circuit/System Verification

Circuit/System Verification

WARNING: This page is about a different variant/trim than selected.
  1. Ignition ON.
  2. Command the Fuel Pump Relay ON and OFF with a scan tool. You should hear and feel a click when you command the fuel pump relay ON and OFF.
    • If a click is not heard or felt 

      Refer to Circuit/System Testing.

    • If a click is heard or felt 
  3. Operate the vehicle within the Conditions for Running the DTC. You may also operate the vehicle within the conditions that you observed from the Freeze Frame/Failure Records data.
  4. Verify the DTC does not set.
    • If the DTC sets 

      Refer to Circuit/System Testing.

    • If the DTC does not set 
  5. All OK.