Conditions for Running the DTC

WARNING: This page is about a different variant/trim than selected.

P0601, P0602

These DTCs run once per ignition cycle.

P0606

DTC P0606 runs continuously when the engine speed is greater than 1, 200 RPM.

P060B, P062F

These DTCs run continuously when the ignition is ON.

P061C

DTC P061C runs continuously when the engine speed is greater than 600 RPM.

P064D

Engine run time is greater than 8 s.
Engine speed is between 500-4, 500 RPM.
Battery voltage is greater than 11 V.
DPF regeneration is not active.
Fuel injection quantity is greater than 2 mm³
P064D runs continuously when the above conditions are met for greater than 6 s.

P262B

Battery voltage is greater than 11 V for greater than 3 s.
The ECM is powered down for greater than 20 s.
P262B runs once per ignition cycle.