Conditions for Running the DTC
WARNING: This page is about a different variant/trim than selected.
P057B
- DTCs P057C or P057D are not set.
- Ignition voltage is greater than 10 V.
- Shift lever has been in Park at least once during key ON.
- Shift lever is not in Park.
- Vehicle speed is 8 km/h (5 MPH) or greater.
- Accelerator Pedal Position is less than 5%.
- DTC runs continuously when above conditions are met.
P057C or P057D
- Ignition voltage is greater than 10 V.
- DTC runs continuously when above condition is met.