Circuit/System Verification
WARNING: This page is about a different variant/trim than selected.
- Ignition ON.
- Observe the DTC information with a scan tool. Verify no other DTCs are set.
- If other DTCs are set
Refer to Diagnostic Trouble Code (DTC) List - Vehicle for further diagnosis.
- If no other DTCs are set
- If other DTCs are set
- Verify there are no aftermarket performance enhancing devices installed on the vehicle.
- Worn or failed accessory drive components may cause this DTC to set.
- Verify the proper fuel is used. Refer to Fuel System Specifications and Contaminants-in-Fuel Diagnosis .
- Operate the vehicle within the Conditions for Running the DTC. You may also operate the vehicle within the conditions that you observed from the Freeze Frame/Failure Records data.
- Verify the DTC does not set.
- If the DTC sets
Refer to Diagnostic Aids .
- If the DTC does not set
- If the DTC sets
- All OK.