LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2015 >> Cruze LT, Automatic Trans >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 12 (Engine Controls And Fuel - 2.0L (LUZ) Diesel - DTC P0430 To DTC P2080) >> Diagnostic Information and Procedures >> DTC P0545, P0546, P2032, P2033, P242C or P242D: Exhaust Gas Temperature Sensor Circuit >> Repair Verification

Repair Verification

WARNING: This page is about a different variant/trim than selected.
  1. Install any components or connectors that have been removed or replaced during diagnosis.
  2. Perform any adjustment, programming or setup procedures that are required when a component or module is removed or replaced.
  3. Clear the DTCs.
  4. Ignition Off, all vehicle systems Off, including retained accessory power (RAP) and the scan tool. This may take up to 2 minutes.
  5. Duplicate the Conditions for Running the DTC and use the Freeze Frame/Failure Records, if applicable, in order to verify the DTC does not reset.
    • If the DTC does not set 
  6. Engine running for 60 s.
  7. Engine Off, ignition On, perform the Reductant System Data Reset with a scan tool in order to clear the reductant lamp, if illuminated.
    • If the reductant lamp does not turn Off 

      A condition with the system still exists.

    • If the reductant lamp does turn Off 
  8. All OK.