Circuit/System Verification
WARNING: This page is about a different variant/trim than selected.
- Ignition ON.
- Command the Positive Crankcase Ventilation Heater ON and OFF with a scan tool while observing the following control circuit status parameters:
- Positive Crankcase Ventilation Heater Control Circuit Open Test Status
- Positive Crankcase Ventilation Heater Control Circuit Low Voltage Test Status
- Positive Crankcase Ventilation Heater Control Circuit High Voltage Test Status
Each parameter should not display Malfunction.
- If Malfunction is displayed
Refer to Circuit/System Testing.
- If Malfunction is not displayed
- Operate the vehicle within the Conditions for Running the DTC. You may also operate the vehicle within the conditions that you observed from the Freeze Frame/Failure Records data.
- Verify the DTC does not set.
- If the DTC sets
Refer to Circuit/System Testing.
- If the DTC does not set
- If the DTC sets
- All OK.