LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2015 >> Cruze LT, Automatic Trans >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 12 (Engine Controls And Fuel - 2.0L (LUZ) Diesel - DTC P0430 To DTC P2080) >> Diagnostic Information and Procedures >> DTC P040F: Exhaust Gas Recirculation (EGR) Temperature Sensor >> Component Testing

Component Testing

WARNING: This page is about a different variant/trim than selected.
  1. Ignition OFF, disconnect the harness connector at the B130 Exhaust Gas Recirculation Temperature Sensor.
  2. Verify the resistance between the signal terminal 1 and the low reference circuit terminal 2 is within the range specified in the Temperature Versus Resistance (EGT Sensors) , Temperature Versus Resistance (EGR Temperature Sensors) , Temperature Versus Resistance (Reductant Injector) , Temperature Versus Resistance (Reductant Tank Temperature Sensor) and Temperature Versus Resistance (Engine Coolant Temperature Sensor) Table.
    NOTE: The J 25070  may be used to evaluate the sensor under high temperature conditions.
    • If not within the range specified 

      Replace the B130 Exhaust Gas Recirculation Temperature Sensor.

    • If within the range specified 
  3. Test for infinite resistance between each terminal and the sensor housing/case.
    • If less than infinite resistance 

      Replace the B130 Exhaust Gas Recirculation Temperature Sensor.

    • If infinite resistance 
  4. All OK
scientia non olet · About LEMON Manuals