Circuit/System Verification
WARNING: This page is about a different variant/trim than selected.
- Ignition ON, verify with a scan tool that the Crankshaft Position Variation Learn Status - Engine Speed Range 1 parameter displays Complete.
- If the parameter does not display Complete
Refer to Circuit/System Testing .
- If the parameter displays Complete
- If the parameter does not display Complete
- Operate the vehicle within the Conditions for Running the DTC. You may also operate the vehicle within the conditions that you observed from the Freeze Frame/Failure Records data.
- Verify the DTC does not set.
- If the DTC sets
Refer to Circuit/System Testing .
- If the DTC does not set
- If the DTC sets
- All OK.