Circuit/System Verification
WARNING: This page is about a different variant/trim than selected.
- Verify DTC P02E2, P02E3, P02EB, P0697, P122C, P122E or P122F is not set.
- If any of the DTCs are set
Refer to Diagnostic Trouble Code (DTC) List - Vehicle .
- If none of the DTCs are set
- If any of the DTCs are set
- Ignition ON, verify the scan tool Intake Air Flow Valve Position Sensor voltage is between 3.7-4.7 V and changes when commanding the Intake Air Flow Valve Motor between 0-100%.
- If not between 3.7-4.7 V or does not change
Refer to Circuit/System Testing .
- If between 3.7-4.7 V and changes
- If not between 3.7-4.7 V or does not change
- All OK.