Conditions for Setting the DTC

WARNING: This page is about a different variant/trim than selected.

P02E0

The ECM detects an open circuit condition of the intake air flow valve control circuit for greater than 1 s.

P02E2

The ECM detects that the intake air flow valve control circuit voltage is less than a calibrated threshold for greater than 0.5 s.

P02E3

The ECM detects that the intake air flow valve control circuit voltage is greater than a calibrated threshold for greater than 0.5 s.

P02EB

The ECM detects that the commanded state of the driver and the actual state of the control circuit do not match for greater than 2 s.

P122C

The ECM detects a short circuit on the intake air flow valve control circuit voltage for greater than 0.5 s.

P122E

The ECM detects that the intake air flow valve control circuit 2 voltage is less than a calibrated threshold for greater than 0.5 s.

P122F

The ECM detects that the intake air flow valve control circuit 2 voltage is greater than a calibrated threshold for greater than 0.5 s.