Circuit/System Verification
WARNING: This page is about a different variant/trim than selected.
- Ignition On.
- Verify DTCs P0030, P0031, P0032, P0053, P064D or P2A00 are not set.
- If any of the DTCs are set
Refer to Diagnostic Trouble Code (DTC) List - Vehicle .
- If none of the DTCs are set
- If any of the DTCs are set
- Engine idling at normal operating temperature.
- Verify the scan tool HO2S 1 lambda parameter is greater than 0.2 Lambda.
- If not greater than 0.2 Lambda
Refer to Circuit/System Testing .
- If greater than 0.2 Lambda
- If not greater than 0.2 Lambda
- Operate the vehicle within the Conditions for Running the DTC. You may also operate the vehicle within the conditions that you observed from the Freeze Frame/Failure Records data.
- Verify the DTC does not set.
- If the DTC sets
Refer to Circuit/System Testing .
- If the DTC does not set
- If the DTC sets
- All OK.