Component Testing
WARNING: This page is about a different variant/trim than selected.
- Ignition OFF, remove the appropriate sensor below.
- Engine Coolant Temperature Sensor
- IAT Sensor 1
- Test the appropriate sensor by varying the sensor temperature while monitoring the sensor resistance. Compare the readings with the Temperature Versus Resistance (EGT Sensors)
, Temperature Versus Resistance (EGR Temperature Sensors)
, Temperature Versus Resistance (Reductant Injector)
, Temperature Versus Resistance (Reductant Tank Temperature Sensor)
, Temperature Versus Resistance (Engine Coolant Temperature Sensor)
, Temperature Versus Resistance - Intake Air Temperature Sensor (Bosch Sensor)
and Temperature Versus Resistance - Intake Air Temperature Sensor (Delco Sensor)
table and verify that the resistance is within 5% of the specification.
- If not within the specified range
Replace the Sensor.
- If within the specified range
- If not within the specified range
- All OK.