Circuit/System Description
WARNING: This page is about a different variant/trim than selected.
The sensors listed below are integrated within the multifunction intake air sensor:
- Intake Air Temperature (IAT) sensor 1
- IAT sensor 2
- Humidity sensor
- MAF sensor
- Barometric pressure (BARO) sensor 2
The intake air temperature (IAT) sensor 1 is a variable resistor that changes the voltage on the engine control module (ECM) supplied 5 V signal circuit. The signal varies with inlet air temperature in the sensor bore and is displayed by the scan tool as °C (°F).
The sensors listed below share an ECM supplied 5 V reference circuit:
- IAT sensor 2
- Humidity sensor
- BARO sensor 2
The sensors listed below share an ECM supplied low reference circuit:
- IAT sensor 1
- IAT sensor 2
- Humidity sensor
- BARO sensor 2
An ignition voltage circuit and an ECM low reference circuit are supplied to the MAF sensor.
IAT Sensor 1 - Temperature, Resistance, Voltage Table
| IAT Sensor 1 | IAT Sensor 1 Resistance | IAT Sensor 1 Signal Voltage |
|---|---|---|
| Cold | High | High |
| Warm | Low | Low |