Circuit/System Verification
WARNING: This page is about a different variant/trim than selected.
- Engine idling at normal operating temperature.
- Verify the scan tool MAF Sensor parameter is between 5-40 g/s.
- If not between 5-40 g/s
Refer to Circuit/System Testing .
- If between 5-40 g/s
- If not between 5-40 g/s
- Operate the vehicle within the Conditions for Running the DTC. You may also operate the vehicle within the conditions that you observed from the Freeze Frame/Failure Records data.
- Verify a DTC does not set.
- If the DTC sets
Refer to Circuit/System Testing .
- If the DTC does not set
- If the DTC sets
- All OK.