LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2015 >> Cruze LT, Automatic Trans >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 11 (Engine Controls And Fuel - 2.0L (LUZ) Diesel - DTC P0016 To DTC P0406) >> Diagnostic Information and Procedures >> DTC P0102 or P0103: Mass Air Flow (MAF) Sensor Circuit >> Circuit Description

Circuit Description

WARNING: This page is about a different variant/trim than selected.

The sensors listed below are integrated within the multifunction intake air sensor:

The MAF sensor is an air flow meter that measures the amount of air entering the engine. The engine control module (ECM) uses the MAF sensor signal to provide the correct fuel delivery for all engine speeds and loads. A small quantity of air entering the engine indicates a deceleration or idle condition. A large quantity of air entering the engine indicates an acceleration or high load condition.

The ECM monitors the exhaust gas recirculation (EGR) flow when the EGR valve is commanded ON. The ECM compares the desired MAF to the actual MAF, if the difference is less than or greater than a calibrated threshold level the amount of detected EGR flow is out of range and an EGR DTC will set.

The ECM applies 5 V to the MAF sensor on the MAF sensor signal circuit. The sensor uses the voltage to produce a frequency based on the inlet airflow through the sensor bore. The frequency varies in a range of approximately 2, 300 Hz at idle to near 9, 000 Hz at maximum engine load, depending on engine coolant temperature (ECT).

An ignition voltage circuit and an ECM low reference circuit are also supplied to the MAF sensor.

When the ECT reaches 60°C (140°F) the ECM can command the exhaust gas recirculation (EGR) valve ON and a lower frequency and g/s value will be indicated on the scan tool.

The sensors listed below share an ECM supplied 5 V reference circuit:

The sensors listed below share an ECM supplied low reference circuit:

scientia non olet · About LEMON Manuals