Circuit/System Verification
WARNING: This page is about a different variant/trim than selected.
- Engine Running, verify with the scan tool that the difference between the Fuel Rail Pressure Sensor and the Desired Fuel Rail Pressure parameters is less than 690 kPa (100 psi).
- If greater than 690 kPa (100 psi)
Refer to Circuit/System Testing
- If less than 690 kPa (100 psi)
- If greater than 690 kPa (100 psi)
- Operate the vehicle within the Conditions for Running the DTC. You may also operate the vehicle within the conditions that you observed from the Freeze Frame/Failure Records data.
- Verify the DTC does not set.
- If the DTC sets
Refer to Circuit/System Testing
- If the DTC does not set
- If the DTC sets
- All OK.