Static Test
WARNING: This page is about a different variant/trim than selected.
- Ignition OFF, disconnect the harness connector at the Q41 Turbocharger Vane Position Control Solenoid Valve.
- Test for 5-20 Ω between the control circuit terminal 1 and the ignition circuit terminal 2 of the Q41 Turbocharger Vane Position Control Solenoid Valve.
- If not between 5-20 Ω
Replace the Q41 Turbocharger Vane Position Control Solenoid Valve.
- If between 5-20 Ω
- If not between 5-20 Ω
- Test for infinite resistance between each terminal and the Q41 Turbocharger Vane Position Control Solenoid Valve housing/case.
- If not infinite resistance
Replace the Q41 Turbocharger Vane Position Control Solenoid Valve.
- If infinite resistance
- If not infinite resistance
- All OK