Dynamic Test
WARNING: This page is about a different variant/trim than selected.
- Install a 10 A fused jumper wire between the ignition circuit terminal 2 and 12 V. Install a jumper wire between the control circuit terminal 1 and ground.
- Verify the Q41 Turbocharger Vane Position Control Solenoid Valve clicks.
- If the Q41 Turbocharger Vane Position Control Solenoid Valve does not click
Replace the Q41 Turbocharger Vane Position Control Solenoid Valve.
- If the Q41 Turbocharger Vane Position Control Solenoid Valve clicks
- If the Q41 Turbocharger Vane Position Control Solenoid Valve does not click
- All OK