Turbocharger Vane Position Control Solenoid Valve Static Test
WARNING: This page is about a different variant/trim than selected.
- Ignition Off, disconnect the harness connector at the Q41 Turbocharger Vane Position Control Solenoid Valve.
- Test for 15-19 Ω between the control terminal 1 and the ignition circuit terminal 2.
- If not between 15-19 Ω
Replace the Q41 Turbocharger Vane Position Control Solenoid Valve.
- If between 15-19 Ω
- If not between 15-19 Ω
- All OK