Repair Verification
WARNING: This page is about a different variant/trim than selected.
- Install any components that have been removed or replaced during diagnosis.
- Perform any adjustments, programming or setup procedures that are required when a component is removed or replaced.
- Clear the DTCs with a scan tool.
- Turn OFF the ignition for 60 s
- Operate the vehicle within the Conditions for Running the DTC.
- Verify the scan tool Catalyst Monitor Not At Idle Test Conditions Met parameter changes to Yes.
- If Yes is not displayed
Refer to step 5.
- If Yes is displayed
- If Yes is not displayed
- When the conditions are safe, stop and idle the vehicle in gear (If equipped with automatic transmission) or neutral (If equipped with manual transmission).
- Verify the Catalyst Monitor Test Result parameter displays Pass when performing the steps listed below:
- Apply the service brake.
- Monitor the scan tool Catalyst Monitor Test State parameter. When the parameter indicates Active, the Catalyst Monitor Test is running.
- Continue to monitor the parameter. When the parameter indicates Inactive, the Catalyst Monitor Test has completed.NOTE: When the test has completed, the Catalyst Monitor Test Counter parameter will increment by one and the Catalyst Monitor Test Result parameter will indicate Passed, Failed or No Result.
- If the Catalyst Monitor Test Result parameter indicates No Result
Repeat steps 5- 8 until the Test Result parameter indicates Passed or Failed
- If the Catalyst Monitor Test Result parameter indicates Failed
Refer to Circuit/System Testing
- If the Catalyst Monitor Test Result parameter indicates Pass
- All OK.