LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2015 >> Cruze LT, Automatic Trans >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 10 (Engine Controls And Fuel - 1.8L (LUW, LWE) - DTC P0010 To DTC P0442) >> Diagnostic Information and Procedures >> DTC P0412, P041F or P044F: Secondary Air Injection Valve Control Circuit >> Circuit/System Verification

Circuit/System Verification

WARNING: This page is about a different variant/trim than selected.
  1. Ignition ON
  2. Verify a click is heard or felt from the KR26 Secondary Air Injection Solenoid Valve Relay when commanding the Secondary Air Injection Solenoid Valve ON and OFF with a scan tool.
    • If a click is heard or felt 
  3. Verify the circuit status parameters listed below do not display Malfunction when commanding the Secondary Air Injection Solenoid Valve ON and OFF with a scan tool:
    • Secondary Air Injection Solenoid Valve Control Circuit Low Voltage Test Status
    • Secondary Air Injection Solenoid Valve Control Circuit Open Test Status
    • Secondary Air Injection Solenoid Valve Control Circuit High Voltage Test Status
    • If Malfunction is not displayed 
  4. Operate the vehicle within the Conditions for Running the DTC. You may also operate the vehicle within the conditions that you observed from the Freeze Frame/Failure Records data.
  5. Verify a DTC does not set.
    • If a DTC does not set 
  6. All OK