Circuit/System Verification

WARNING: This page is about a different variant/trim than selected.

Ignition ON.
Verify DTC P0641 or P0651 is not set.
- If any of the DTCs are set
  Refer to DTC P0641, P0651, P0697 or P06A3 (ECM) .
- If none of the DTCs are set
Engine Running.
Verify the scan tool parameters listed below increment:
- Exhaust Camshaft Position Active Counter
- Intake Camshaft Position Active Counter
- If any counter does not increment
  Refer to Circuit/System Testing .
- If all counters increment
Operate the vehicle within the Conditions for Running the DTC. You may also operate the vehicle within the conditions that you observed from the Freeze Frame/Failure Records data.
Verify the DTC does not set.
- If the DTC sets
  Refer to Circuit/System Testing .
- If the DTC does not set
All OK.