Conditions for Running the DTC

• DTCs P0016, P0101, P0102, P0103, P0112, P0113, P0117, P0118, P0121, P0122, P0123, P0222, P0223, P0315, P0335, P0336, P0502, P0651 and P2135 are not set.
• The engine speed is greater than 1000 RPM.
• The crankshaft and camshaft are synchronized.
• The ignition voltage is between 11-18 V.
• The engine coolant temperature (ECT) sensor is between -7 to +125°C (+19 to +257°F).
• The A/C compressor clutch is not changing states.
• The fuel tank level is greater than 15%.
• The ECM is not in fuel cut-off or deceleration fuel cut-off mode.
• The ECM is not receiving a rough road signal.
• The throttle angle is steady within 5%.
• The throttle angle is greater than 3% when the vehicle speed is greater than 5 km/h (3 MPH).
• The transmission is not changing gears.
• The antilock brake system (ABS) and the traction control system, if equipped, is not active.

The DTCs run continuously when the above conditions are met.