Circuit/System Verification

WARNING: This page is about a different variant/trim than selected.

Ignition ON, verify that DTC P0641, P0651, P0697 or P06A3 is not set.
- If any of the DTCs are set
  Refer to DTC P0641, P0651, P0697 or P06A3 (ECM) for further diagnosis.
- If none of the DTCs are set
Ignition ON.
NOTE: To minimize the effects of residual engine heat and sensor internal heating elements, perform Steps 1 and 2 of this verification procedure only if the ignition has been OFF for 8 hours or more.
Verify the following scan tool parameters are within 55°C (99°F) of each other.
- Start-Up IAT Sensor 1
- IAT Sensor 2
- Start-Up ECT
- If not within 55°C (99°F)
  Refer to Circuit/System Testing .
- If within 55°C (99°F)
Engine idling, verify the scan tool Intake Air Humidity parameter is between 5 and 90%.
- If not between 5 and 90%
  Refer to Circuit/System Testing .
- If between 5 and 90%
Operate the vehicle within the conditions for running the DTC. You may also operate the vehicle within the conditions that you observed from the freeze frame/failure records data.
Verify the DTCs do not set.
- If any of the DTCs set
  Refer to Circuit/System Testing .
- If none of the DTCs set
All OK