Conditions for Running the DTC
WARNING: This page is about a different variant/trim than selected.
DTC P0068
- DTC P0102, P0103, P0107, P0108 or P0651 is not set
- The engine speed is at least 800 RPM.
- The Ignition signal is at least 6.0 V.
- The throttle actuator control system is not in reduced power mode, without LUW
- The DTC runs continuously when the above conditions are met.
DTC P1101
- DTC P0102, P0103, P0107, P0108, P0117, P0118, P0128, P0335 or P0336 is not set
- The engine speed is between 400-7, 000 RPM; 400-6, 000 RPM with LUW
- The engine coolant temperature (ECT) is between -7 to +125°C (+19 to +257°F).
- The intake air temperature (IAT) is between -20 to +125°C (-4 to +257°F).
- The DTC runs continuously when the above conditions are met.