LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2015 >> Cruze LT, Automatic Trans >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 1 (Automatic Transmission - AF40-6) >> Diagnostic Information and Procedures >> DTC P0976 or P0977: Shift Solenoid Valve 2 Control Circuit >> Circuit/System Verification

Circuit/System Verification

WARNING: This page is about a different variant/trim than selected.
  1. Engine running, ensure the transmission fluid temperature is between 50-80°C (122-176°F).
  2. Engine running in Park position, parking brake applied, place the gear select lever in each gear position for 2-3 s. Return the gear select lever to the Park position. Place the gear selector in Reverse for 5 s and then idle vehicle for 5 s.
  3. Verify the scan tool data Shift Solenoid Valve 2 parameter displays ON.
    • If the parameter displays ON 
  4. Operate the vehicle within the Conditions for Running the DTC. It may be helpful to operate the vehicle within the conditions identified from the Freeze Frame/Failure Records data.
    • If the DTC is not set 
  5. All OK.
scientia non olet · About LEMON Manuals