Circuit/System Verification

WARNING: This page is about a different variant/trim than selected.

Verify the transmission fluid level, color and odor is correct. Refer to Transmission Fluid Drain and Fill .
- If the fluid level, color or odor is not correct
  Refer to Fluid Leak Diagnosis
- If the fluid level, color or odor is correct
Perform the Line Pressure Check to verify proper transmission line pressure.
- If the line pressure not OK
  Repair or replace the damaged component as necessary.
- If the line pressure OK
Verify DTC P0868 or P0869 is not set.
- If the DTC is set
  Program the TCM.
- If the DTC is not set
Verify the DTC does not set while operating the vehicle under the Conditions for Running the DTC.
- If the DTC is set
  Replace the K71 Transmission Control Module
- If the DTC is not set
All OK.