Circuit/System Verification
WARNING: This page is about a different variant/trim than selected.
- Operate the vehicle at 16-32 km/h (10-20 MPH) while observing the scan tool Transmission OSS parameter.
- Verify the Transmission OSS parameter should vary with the vehicle speed and not drop out.
- If the OSS parameter does not change with the vehicle speed
Refer to Circuit/System Testing
- If the OSS parameter changes with the vehicle speed
- If the OSS parameter does not change with the vehicle speed
- Operate the vehicle within the Conditions for Running the DTC. It may be helpful to operate the vehicle within the conditions identified from the Freeze Frame/Failure Records data.
- Verify the DTC do not set.
- If the DTC is set
Refer to Circuit/System Testing
- If the DTC is not set
- If the DTC is set
- All OK.