Circuit/System Verification
WARNING: This page is about a different variant/trim than selected.
- Engine idling, observe the scan tool Transmission ISS parameter while varying the engine speed.
- Verify the Transmission ISS parameter should change with the engine speed and not drop out.
- If the ISS parameter does not change with the engine speed
Refer to Circuit/System Testing
- If the ISS parameter changes with the engine speed
- If the ISS parameter does not change with the engine speed
- Operate the vehicle within the Conditions for Running the DTC. It may be helpful to operate the vehicle within the conditions identified from the Freeze Frame/Failure Records data.
- Verify the DTC do not set.
- If the DTC is set
Refer to Circuit/System Testing
- If the DTC is not set
- If the DTC is set
- All OK.