Circuit/System Testing
WARNING: This page is about a different variant/trim than selected.
- Inspect the transmission cooling system for restrictions or damage, inducing any auxiliary cooler if equipped. Refer to Transmission Overheats
.
- If a defect is found
Repair or replace the damaged components as necessary.
- If no defect found
- If a defect is found
- Perform the Line Pressure Check to verify proper transmission line pressure.
- If the line pressure not OK
Repair or replace the damaged component as necessary.
- If the line pressure OK
- If the line pressure not OK
- Perform the Road Test to verify that not DTCs are set.
- If any DTCs are set
- If none DTCs are set
- All OK.