Overview SLB1, SLC1, SLC2 and SLC3 Solenoids
WARNING: This page is about a different variant/trim than selected.
| Callout | Component Name |
|---|---|
| 1 | On |
| 2 | Off |
| 3 | Ex |
| slc1 | Solenoid Valve SLC1 |
| slc2 | Solenoid Valve SLC2 |
| slc3 | Solenoid Valve SLC3 |
| slb1 | Solenoid Valve SLB1 |
The PWM controlled solenoid valve is mounted in the transmission valve housing and controls the pressure in clutch C1. The valve is active in gear positions P, R, N, D (gears 5 and 6).
The control module activates the valve by pulsing it with B+ (300 Hz PWM). The valve is powered from control module pin 11 in the connector that makes contact directly with the transmission on the bottom of the control module. The valve is grounded from pin 10. The current varies between 0-1000 mA. The solenoid is normally open and the hydraulic pressure drops as the current increases.