Overview S1 and S2 Solenoids
WARNING: This page is about a different variant/trim than selected.
| Callout | Component Name |
|---|---|
| 1 | On |
| 2 | Off |
| s1 | Solenoid Valve S1 |
| s2 | Solenoid Valve S2 |
The normally closed solenoid valve is mounted in the transmission valve housing and is used together with S1 to apply pressure to brake B2 for engine braking in 1st gear.
The control module activates the valve by applying B+ to it. The valve is powered from control module pin 2 in the connector in direct contact with the transmission on the bottom of the control module. The valve is grounded in the valve housing.