LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2015 >> Cruze LT, Automatic Trans >> Repair and Diagnosis >> External Pages >> Different car >> Section 98 (Automatic Transmission - 6T40 (MH8 MHB) - Repair Instructions - Off Vehicle) >> Repair Instructions - Off Vehicle >> Manual Shift Detent Lever with Shaft Position Switch Assembly and Park Pawl Actuator Removal >> Manual Shaft Detent (w/Shift Position Switch) Lever Assembly Removal

Manual Shaft Detent (w/Shift Position Switch) Lever Assembly Removal

WARNING: This page is about a different car, the 2015 Chevrolet Trax and 2015 Buick Encore. However, it is still accessible from the selected car via links, so may be relevant.
Fig 1: Identifying Manual Shaft Detent Lever Assembly
GM1891310Courtesy of GENERAL MOTORS COMPANY
Manual Shaft Detent (w/Shift Position Switch) Lever Assembly Removal

Callout Component Name
1 Manual Shaft Detent Lever Hub Pin
NOTE:

Use side cutter to remove the pin (1) and discard.
2 Manual Shift Shaft Pin
NOTE:

Discard the pin. It is not reusable.

Special Tools

  • DT-23129  Universal Seal Remover
  • GE-6125-1B  Slide Hammer

For equivalent regional tools, refer to Special Tools .
3 Manual Shaft
4 Manual Shaft Detent (w/Shift Position Switch) Lever Assembly
5 Park Pawl Actuator Assembly
scientia non olet · About LEMON Manuals