LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2015 >> Cruze LT, Automatic Trans >> Repair and Diagnosis >> External Pages >> Different car >> Section 96 (Transmission Cooling System) >> Diagnostic Information and Procedures >> Transmission Fluid Cooler Flushing and Flow Test >> Code Recording Procedure

Code Recording Procedure

WARNING: This page is about a different car, the 2015 Chevrolet Trax and 2015 Buick Encore. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: View Of Main Function Switch CODE Position
    GM1212346Courtesy of GENERAL MOTORS COMPANY
  1. Turn the main function switch to the CODE position.
    2. NOTE:
    • If power is interrupted prior to the recording of the seven-character code, the code will be lost and the flow rate test will need to be repeated.
    • The flow test must run for a minimum of 8-10 seconds and be above 0.5 GPM for a code to be generated.
  2. Record TESTED flow rate, temperature, cycle and seven-character flow code information on repair order.
scientia non olet · About LEMON Manuals