Rocker Panel Rear Molding Replacement

WARNING: This page is about a different car, the 2015 Chevrolet Trax and 2015 Buick Encore. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Rocker Panel Rear Molding

Courtesy of GENERAL MOTORS COMPANY

Callout	Component Name
Preliminary Procedure Open the rear side door.
1	Rocker Panel Rear Molding Upper Retainer (Qty 3)
2	Rocker Panel Rear Molding Lower Retainer (Qty 2)
3	Tire Deflector Push-Pin (Qty 2)
4	Rear Wheelhouse Liner Bolt (Qty 2) CAUTION: Refer to Fastener Caution .
5	Rocker Panel Rear Molding Procedure Remove the two rear wheelhouse liner bolts. Release the two tire deflector push-pin. Release the upper and lower rocker panel rear molding retainers. Pull the rocker panel rear molding rearward to release the molding from the rocker panel front molding retaining tabs and remove from the vehicle.