Front Bumper Fascia Upper Molding Replacement (Encore)

WARNING: This page is about a different car, the 2015 Chevrolet Trax and 2015 Buick Encore. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Front Bumper Fascia Upper Molding (Encore)

Courtesy of GENERAL MOTORS COMPANY

Callout	Component Name
Preliminary Procedure Remove the front bumper fascia. Refer to Front Bumper Fascia Replacement (Encore) .
1	Front Bumper Fascia Upper Molding Procedure Place the bumper fascia face down on a clean protected surface. Release the five locking tabs while carefully pulling the front bumper fascia upper molding from the front fascia.