Component Testing
WARNING: This page is about a different car, the 2015 Chevrolet Trax and 2015 Buick Encore. However, it is still accessible from the selected car via links, so may be relevant.
Static Test
- Ignition Off, disconnect the harness connector at the appropriate solenoid Valve.
- Test for 20-27 Ω between terminal 1 and terminal 2 of the solenoid valve.
- If not between 20-27 Ω
Replace the solenoid Valve.
- If between 20-27 Ω
- If not between 20-27 Ω
- All OK
Dynamic Test
- Install a 10 A fused jumper wire between the Ignition terminal 2 and 12 V. Install a jumper wire between the control terminal 1 and ground.
- Verify the solenoid clicks.
- If the solenoid does not click
Replace the solenoid Valve.
- If the solenoid clicks
- If the solenoid does not click
- All OK