Circuit/System Verification
WARNING: This page is about a different car, the 2015 Chevrolet Trax and 2015 Buick Encore. However, it is still accessible from the selected car via links, so may be relevant.
- Ignition ON.
- Verify no HO2S heater DTCs are set.
- If a DTC is set
Refer to Diagnostic Trouble Code (DTC) List - Vehicle .
- If a DTC is not set
- If a DTC is set
- Verify none of the following conditions exist:
- Lean or rich fuel injectors-Refer to Fuel Injector Diagnosis
- Water intrusion in the HO2S harness connector
- Low or high fuel system pressure, refer to Fuel System Diagnosis (LUJ)Fuel System Diagnosis (LUV) .
- Fuel that is contaminated, refer to Alcohol/Contaminants-in-Fuel Diagnosis .
- Fuel saturation of the evaporative emission (EVAP) canister
- Exhaust leaks
- Engine vacuum leaks
- Engine oil consumption-Refer to Oil Consumption Diagnosis
- Engine coolant consumption-Refer to Loss of Coolant
- If any of the conditions exist
Repair as necessary.
- If any of the conditions exist
- Operate the vehicle within the Conditions for Running the DTC. You may also operate the vehicle within the conditions that you observed from the Freeze Frame/Failure Records data.
- Verify the DTC does not set.
- If the DTC sets
Test or replace the appropriate B52 HO2S.
- If the DTC does not set
- If the DTC sets
- All OK.