Circuit/System Verification
WARNING: This page is about a different car, the 2015 Chevrolet Trax and 2015 Buick Encore. However, it is still accessible from the selected car via links, so may be relevant.
- Ignition ON.
- Verify the scan tool ECT Sensor parameter is warmer than -40° C (-40° F) and colder than 150° C (302° F) and changes with engine run time.
- If colder than -39° C (-38° F) or warmer than 149° C (300° F) or does not change
Refer to Circuit/System Testing.
- If warmer than -40° C (-40°F) and colder than 150° C (302° F) and changes
- If colder than -39° C (-38° F) or warmer than 149° C (300° F) or does not change
- Operate the vehicle within the Conditions for Running the DTC. You may also operate the vehicle within the conditions that you observed from the Freeze Frame/Failure Records data.
- Verify the DTC does not set.
- If the DTC sets
Refer to Circuit/System Testing.
- If the DTC does not set
- If the DTC sets
- All OK.