LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2015 >> Cruze LT, Automatic Trans >> Repair and Diagnosis >> External Pages >> Different car >> Section 89 (Engine Controls And Fuel - 1.4L (LUJ LUV) - DTC P0010 To DTC P0246) >> Diagnostic Information and Procedures >> DTC P0107 or P0108: Manifold Absolute Pressure (MAP) Sensor >> Circuit/System Verification

Circuit/System Verification

WARNING: This page is about a different car, the 2015 Chevrolet Trax and 2015 Buick Encore. However, it is still accessible from the selected car via links, so may be relevant.
  1. Ignition ON.
  2. Verify that DTC P0641, P0651, P0697, or P06A3 is not set.
    • If none of the DTCs are set 
  3. Engine idling, verify the scan tool MAP voltage parameter is between 0.3 and 4.8 V and changes with accelerator pedal input.
    • If not between 0.3 and 4.8 V or does not change 

      Refer to Circuit/System Testing.

    • If between 0.3 and 4.8 V and changes 
  4. Operate the vehicle within the Conditions for Running the DTC. You may also operate the vehicle within the conditions that you observed in the Freeze Frame/Failure Records data.
  5. Verify the DTC does not set.
    • If the DTC sets 

      Refer to Circuit/System Testing.

    • If the DTC does not set 
  6. All OK.