Component Testing
WARNING: This page is about a different car, the 2015 Chevrolet Trax and 2015 Buick Encore. However, it is still accessible from the selected car via links, so may be relevant.
Turbocharger Boost/Intake Air Temperature sensor
- Ignition OFF, disconnect the harness connector at the B111B Turbocharger Boost/Intake Air Temperature sensor.
- Test the IAT sensor 3 by varying the sensor temperature while monitoring the sensor resistance. Compare the readings with the Temperature Versus Resistance - Intake Air Temperature Sensor (Bosch Sensor)Temperature Versus Resistance - Intake Air Temperature Sensor (Delco Sensor)
table for the appropriate sensor. The resistance values should be in range of the table values.
- If not within the specified range.
Replace the B111B Turbocharger Boost/Intake Air Temperature sensor.
- If within the specified range.
- If not within the specified range.
- All OK
NOTE:
A thermometer can be used to test the sensor off the vehicle.