LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2015 >> Cruze LT, Automatic Trans >> Repair and Diagnosis >> External Pages >> Different car >> Section 89 (Engine Controls And Fuel - 1.4L (LUJ LUV) - DTC P0010 To DTC P0246) >> Diagnostic Information and Procedures >> DTC P0010, P0013, or P2088-P2091: Camshaft Position Actuator Solenoid >> Circuit/System Verification

Circuit/System Verification

WARNING: This page is about a different car, the 2015 Chevrolet Trax and 2015 Buick Encore. However, it is still accessible from the selected car via links, so may be relevant.
    NOTE:

    If a crankshaft or camshaft position sensor DTC is set, the Camshaft Position Actuator output control will not function.

  1. Ignition On.
  2. Verify DTC P0335, P0336, P0340, or P0341 is not set.
    • If none of the DTCs are set 
  3. Engine idling, command the Camshaft Position Actuator to 10° while observing the following control circuit status parameters with a scan tool:
    • Exhaust or Intake Camshaft Position Actuator Solenoid Valve Control Circuit Open Test Status
    • Exhaust or Intake Camshaft Position Actuator Solenoid Valve Control Circuit Low Voltage Test Status
    • Intake or Exhaust Camshaft Position Actuator Solenoid Valve Control Circuit High Voltage Test Status
    • If Malfunction is displayed 

      Refer to Circuit/System Testing

    • If Malfunction is not displayed 
  4. Operate the vehicle within the Conditions for Running the DTC. You may also operate the vehicle within the conditions that you observed from the Freeze Frame/Failure Records data.
  5. Verify the DTC does not set.
    • If the DTC sets 

      Refer to Circuit/System Testing.

    • If the DTC does not set 
  6. All OK.
scientia non olet · About LEMON Manuals